We have a few simple steps for installation, ensuring that you get a perfect experience with every VinylMod Overlay®.

1. Clean the area to be applied with the alcohol cleaning pad provided.
2. Prepare the VinylMod Overlay® by firmly rubbing your finger over the clear transfer tape.
3. Peel the white paper backing off the VinylMod Overlay® slowly and carefully.
4. Line up your VinylMod Overlay® to the area of application. Apply firm pressure over VinylMod Overlay®
5. Slowly peel off the clear transfer tape at an angle, being careful not to pull off the VinylMod Overlay® in the process. If the VinylMod Overlay® lifts up, gently place the clear transfer tape back on and apply pressure over the lifted area.
6. Take a step back, and enjoy your new VinylMod.

If you made any mistakes during this process, and your VinylMod Overlay® becomes unusable, feel free to contact one of our VinylMod Customer Representatives using our online chat or email support@vinylmod.com.

If you like your new VinylMod, please share it with your friends and tag us on Facebook, Instagram, or Twitter @VinylMod. And if you haven’t already, please make sure to follow us for promotions and new/upcoming products.

Our Tints are made with top-quality material with air-release technology to reduce the chance of bubbles.  Please follow the steps below to ensure a flawless installation:

1. Clean the surface to remove any oils, wax and other surface contaminants. You can use the isopropyl alcohol pads provided to clean the surface properly.
2. Peel the backing from the vinyl to expose the adhesive. Make sure the tint is applied to the surface quickly to limit the chance of dust and other particles from sticking to the surface. Our air-release tint is a dry application film, no installation fluid is needed.
3. Apply the film to target surface. With a soft squeegee or glove, remove any air trapped in the adhesive by carefully pressing it out. If you encounter creases or wrinkles, simply heat the film, re-position and apply. If the vinyl is not sticking, use heat and press the film into position. If you’ve stretched the film, heat the film after it’s been applied to erase memory in the film and to ensure no shrinkage.